rreda
Board Regular
Posts: 349
|
Post by rreda on Oct 20, 2006 4:05:22 GMT -5
What do you recommend that I use to "glue" the insert into carbon shafts? I want to be able line up my 3 bladed Wasp heads to my 3 feathers. How best to do this, and what do I use?
(super glue, epoxy, hot melt, etc?)
|
|
tedicast
Mod
Ethics Adviser
Posts: 1,335
|
Post by tedicast on Oct 20, 2006 5:19:47 GMT -5
We use Bohning PowerBond. It isn't a fast set, so it gives you time to line up your blades if that is your thing. We like it because it gives you plenty of time to spin test, and adjust broadheads.
|
|
rreda
Board Regular
Posts: 349
|
Post by rreda on Oct 20, 2006 5:31:38 GMT -5
Thanks for the advice. Hope that your back is feeling better. Mine was acting up a bit last week, and I was popping Alieve like candy!
|
|
tedicast
Mod
Ethics Adviser
Posts: 1,335
|
Post by tedicast on Oct 20, 2006 6:06:28 GMT -5
Thanks for the advice. Hope that your back is feeling better. Mine was acting up a bit last week, and I was popping Alieve like candy! I'ne been doing the same with ibupofin. I slept on the heating pad last night, and everytime I woke up I clicked it on again. Feels a little better this morning, but I'm sure after an hour at work it is going to be just as bad as last night. |
|
