SPIKER
Site Guru
THE REAPER'S WRENCH
Made In America
Posts: 4,777
|
Post by SPIKER on Jun 18, 2008 20:56:09 GMT -5
One drawback with the moleskin is that as you shoot, the moleskin wears out...causing the POI to hit lower. You have to know when to change out the skin, and then shoot it in again. A bit of a pain....but the goal is to have a silent deer killing machine....  |
|
bowman
Board Regular
Sept. 2006 Ontario, My Father-inLaw and me
Posts: 417
|
Post by bowman on Jun 20, 2008 5:31:59 GMT -5
There is some Silcone tape on the market that works great for quiting rests you can get it at Cabelas, and Gander Mountain store I'm not sure if Keystone carries it. It stays on well and last a long time.
|
|
azslim
Board Regular
Posts: 452
|
Post by azslim on Jun 20, 2008 19:59:06 GMT -5
The white tubing is probably heat shrink wrap to cover the forks and quiet things down on the draw. I have the same rest on my Vectrix but it didn't come with the tube so can't say for sure.
|
|
royden
Senior Board Member
Posts: 1,349
|
Post by royden on Jun 20, 2008 22:06:33 GMT -5
was this white tube a 1/4" long  there is a spacer that comes in the packet that can go underneath the arrow retainer bar if needed - white teflon 1/4" long |
|
|
|
Post by oldfarmsblueman on Jun 21, 2008 6:46:48 GMT -5
That's it thanks .I think they could put in some instructions as what is in the package beside the Ripcord  |
|
|
|
Post by buckfvr on Jul 12, 2008 15:03:48 GMT -5
on the 2008 models, they come with a standard screw, and a longer screw and the teflon spacer for the containment arm, and the prongs have two additional holes to give you more vertical adjustment ( if needed)....when you use the bottom holes on the prongs (new on 2008 models ), the spacer and screw raise the containment arm to maintain clearances. R
|
|
there is a spacer that comes in the packet that can go underneath the arrow retainer bar if needed - white teflon 1/4" long
